Air Compressors

Place your air source just about anywhere you want it with this relocation kit from VIAIR. Included Parts: - 1/4" NPT (F) Quick Connect Coupler - 1/4" NPT (F) Quick Connect Stud - (2) 1/4" NPT Compression Fittings (For 1/4" Line) - 15 ft. Air Line Tubing - 3 Air Line Clips - 5" Continuous Grommet Learn More

Pressure Switches with Built-in Relay - are heavy duty and moisture resistant. They’re been tested to last 10,000+ cycles. They measure 4.25”L x 2.25”W and come with 1/8” male port fittings. Leads are pre-fitted with insulated 1/4” male push-to-connect terminals that are clearly marked for simple installation. 1/8" NPT Male Port 85 PSI On, 105 PSI Off Learn More

Mounts under the front passenger seat while providing maximum protection from damage and from the elements. Allows the manifold and locker solenoids to be mounted next to the compressor for simple hose routing. Learn More

Designed to fill the market need for a compact sized yet high performance compressed air source for rapid inflation of large tires as well as the high volume air needs of most air powered tools. Learn More

EVO MFG Air Compressor Mount Bracket cleanly mounts the ARB small and large air compressors (Not Twin) high in the engine compartment. Learn More

Up Down Air is built on a third-generation automotive aftermarket industry family legacy that began in the 1950's. Learn More

Ultra Light Duty Onboard Air System can be used to pressurize the included 1.0 gallon air tank for air horn use, off road air locking differential use, and a host of other light duty pneumatic needs. While not intended to inflate tires, this onboard air system provides a reliable smaller volume, in a cost effective package. Please Note: Use thread sealant for proper installation. Teflon tape is not recommended. Properly sealed, recommended torque for 1/8" is 10 ~ 11 ft. lbs. Recommended... Read More Learn More

VIAIR’s X’treme Duty Onboard Air System is a pre-packaged compressed air solution that provides two 350C, 100% duty cycle compressors, a 2.0 gallon air tank, inline pressure regulation, and all components needed to install a working system capable of inflating tires, managing air locking differentials, and more. Please Note: Use thread sealant for proper installation. Teflon tape is not recommended. Properly sealed, recommended torque for 1/8" is 10 ~ 11 ft. lbs. Recommended torque for... Read More Learn More

VIAIR’s Ultra Duty Onboard Air System is a pre-packaged compressed air solution that provides an industry-leading, 200 PSI rated, 100% duty cycle 480C compressor, 2.5 gallon air tank, and all components needed to install a working system capable of inflating tires of virtually any size. Please Note: Use thread sealant for proper installation. Teflon tape is not recommended. Properly sealed, recommended torque for 1/8" is 10 ~ 11 ft. lbs. Recommended torque for 1/4" and 3/8" is 16 ~ 18 ft.... Read More Learn More

120 PSI Air Source Kits come with a low amp-draw, 25% duty cycle, 275C VIAIR compressor mounted on a 150 PSI-rated 1.5 gallon air tank with 5 ports. All Air Source kits come with a pre-wired pressure switch (P/N 20003 / 90-120 PSI). The 120 PSI Air Source Kit comes complete with a 1/4” NPT brass drain cock, 1/4” NPT ASME coded and certified safety valve, 1/2” NPT port compression fitting for 3/8” (I.D.) air line pre-installed. To use, simply connect the pressure switch to fused power,... Read More Learn More