Search results for: 'Programmer for XP SC500-BL'

Learn More

Learn More

Our SafeTCap® ART-143 Rear Lower Coil spring mount was designed as a direct replacement for your Jeep Wrangler TJ and LJ original rear lower coil spring mount on the rear axle. This part should be welded onto the rear axle once the original spring mount is removed and the axle is ground down to clean metal. Our ART-143 is made from 7 gage steel and is CNC cut, bent and assembled by our AWS certified welders in the USA. This part is sold individually and is designed to fit both Driver and... Read More Learn More

Wranglers have weld-nuts inside the frame rails that secure the transfer case skid plate in place. The skid plate also is the transmission and transfer case mount. Typically the bolts are a problem to remove due to rust on the inside of the frame rail. When this happens, access holes are often cut unto the side to facilitate removal of these bolts. This method gives access to dirt and water, which can collect inside the rails and rust them from the inside out. This Safe-T-CapTM kit is a... Read More Learn More

On YJs there is a factory body mount right above the frame at the forward rear leaf spring mounting point. The rubber bushing gets old and cracks, attracting moisture, dirt... and rust. Frame deterioration is a very common problem in this critical suspension mounting point. This unit includes the frame mount and the spring shackle mount. You will need to buy new leaf spring mount bushings for best results. This is a Safe-T-CapTM section that fixes the problem – we make it easy to... Read More Learn More

The front frame rails at the shackle mounts start rusting from the inside out. Rust and constant pressure from the steering box unit can create fatigue in the metal, leading to stress cracks that can cause the steering to fail. These rusted out areas create an extremely unsafe condition and often lead to state safety inspection failures. Our kits are a direct replacement. The left (steering) side has frame with steering box mount and shackle mount, the right side is frame and shackle... Read More Learn More

Our SafeTCap® ART-135-1-S Front Frame Section was designed to cap over the original frame after removing the steering box mount and rotted metal then welding the new frame repair section to the frame. Learn More

Our ART-143 rear lower coil spring mount for the 1997-2006 Jeep Wrangler TJ/LJ was designed as a direct replacement for your original coil spring mount on the rear axle. This part is to be welded on the rear axle once the original spring mount is removed and the axle is ground down to clean metal. Our ART-143 is made from 7 gage steel and is CNC cut, bent and assembled by our AWS certified welders in the USA. This part is sold individually and is designed to fit both Driver and Passenger... Read More Learn More

The CJ’s rear leaf spring mounting point has a factory rubber body mount above it that often leads to deterioration of the frame area. Over time, moisture gets trapped around the leaf spring bushings while dirt and debris get trapped inside the frame rails causing severe rust-through. Cut out the old mount and cut back the rust, then cover with the Safe-T-CapTM and weld in place – you’re back on the road without an expensive full frame replacement. You will need to buy new leaf spring... Read More Learn More

The CJ’s rear leaf spring mounting point has a factory rubber body mount above it that often leads to deterioration of the frame area. Over time, moisture gets trapped around the leaf spring bushings while dirt and debris get trapped inside the frame rails causing severe rust-through. Cut out the old mount and cut back the rust, then cover with the Safe-T-CapTM and weld in place – you’re back on the road without an expensive full frame replacement. You will need to buy new leaf spring... Read More Learn More