Search results for: 'windows 　blind'

This double cardan style CV drive shaft is recommended for Jeep TJ Wrangler models equipped with 4in - 6in suspension lifts or 87-93 Jeep YJ Wrangler models equipped with 4in suspension lifts to prevent driveline vibration and the rear output shaft from breaking. Learn More

Installing the Teraflex High-Angle Rzeppa CV Rear Driveshaft on your Jeep Wrangler JK allows for greater angles than traditional U-joints. Learn More

1987-93 YJ Wrangler Up to 3" lift 20" extended and 16" collapsed Measure from the outer edge of the seal on the original transfer case tailhousing to the center of the differential yoke u-joint. This measurement will be the center to center u-joint measurement for the new drive shaft and should be between 19 and 21 long. CV drive shafts are specifically made for NP231 slip yoke eliminator kits. Shafts are made using quality Dana Spicer components. Slip spline is coated to prevent... Read More Learn More

Maximize your clearance and suspension flex in your 2-door Wrangler JK with a ICON Vehicle Dynamics Rear Driveshaft. Learn More

Maximize your clearance and suspension flex in your 4-door Wrangler Unlimited JK with a ICON Vehicle Dynamics Rear Driveshaft. Learn More

Jeep JK2 and JK4 Front and Rear Rebuild Kit 2007-18 Stock Jeeps use 1 Joint on the Front Driveshaft at the transfer case; 2 Joints on the Rear Driveshaft. Learn More

Rough Country CV Drive Shaft Rear For 1987-93 Jeep Wrangler YJ & TJ 1997-06 4cyl Wrangler With 4" Lift -17.25") Learn More

Rough Country CV Drive Shaft Rear For 1987-93 Jeep Wrangler YJ (With 6" Lift) Learn More

Will only work on fixed yoke style slip yoke eliminator 1310 series yoke Spicer drive shafts and components are as good as they get. This drive shaft is compatible with the RE1811 Slip yoke eliminator kit, Atlas transfer cases and any other 1310 series CV yoke. Measurements are taken center to center on the u-joint with the slip stub at the center of it's travel. measure your vehicle on the ground in the running position to get correct length. Fits These Vehicles: 87-95 Jeep Wrangler... Read More Learn More

Rubicon Express Rear CV Driveshaft T-Case Adapter Flange 2007+ Jeep Wrangler JK 2 Door & Unlimited 4 Door Billet aluminum flange 8mm-1.25 x 25mm socket cap screws Rear transfer case flange adapter. Must be used with the following drive shaft part numbers: #RE1887-240 (2-door) and RE1887-430 (4-door). Learn More