Search results for: 'Rough country CV DRIVE SHAFT FOR 18-25'

Rough Country CV Drive Shaft Rear For 2003-06 Jeep Wrangler TJ Rubicon (With 4-6" Lift) Measurement: 16.875-inches - 20.125-inches (18.5 Running Length) Learn More

Rough Country CV Drive Shaft Rear For 1987-93 Jeep Wrangler YJ & TJ 1997-06 4cyl Wrangler With 4" Lift -17.25") Learn More

Rough Country CV Drive Shaft Rear For 2000-06 Jeep Wranler TJ Non Rubicon (With 6cyl, Dana 44, Manual Trans & 4" Lift -16.75) Learn More

Rough Country CV Drive Shaft Rear For 1997-06 Jeep Wranler TJ Non Rubicon (With 6cyl, Dana 35 & 44, 4" Lift -16.00) Learn More

2007-15 JK Wrangler and Rubicon 2-Door Double-Cardan joint Direct bolt on drive shaft Extended Length = 22.50" Compressed Length = 26.50" 1310 U-joints New original equipment JK Wranglers use drive shafts that have Rzeppa CV joints similar to most front wheel drive cars. These CV joints are fine for normal car applications but when you lift your Jeep or put on larger tires and drive your Jeep off road, these joints are not up to the task! Rugged Ridge has developed a solution for this... Read More Learn More

1997-06 TJ Wrangler Use only with slip-yoke eliminator kit. 2-6" of Lift 18" extended and 14" collapsed Reduce or eliminate driveline vibration with a CV-equipped drive shaft. Constant Velocity (CV) joints use two U-joints (double cardan style) in the place of a single U-joint. This smoothes out the driveline angle and reduces vibration due to extreme lifts or driveline changes. Learn More

1987-93 YJ Wrangler Up to 3" lift 20" extended and 16" collapsed Measure from the outer edge of the seal on the original transfer case tailhousing to the center of the differential yoke u-joint. This measurement will be the center to center u-joint measurement for the new drive shaft and should be between 19 and 21 long. CV drive shafts are specifically made for NP231 slip yoke eliminator kits. Shafts are made using quality Dana Spicer components. Slip spline is coated to prevent... Read More Learn More

Slip: 3.50" Length: 33.75-37.25" Running Length 35.50" Learn More

1994-95 YJ Wrangler With up to 3" lift 20" extended and 16" collapsed Learn More

1997-06 TJ Wrangler Bare Steel Fits 3.5 - 6" lift for Mega Short SYE ONLY CV Style Custom designed drive shaft for use with our Mega Short Slip Yoke Eliminator kit. Works in combination with the Mega Short SYE on 97-06 Jeep Wranglers with a suspension lift of 3.5"to 6". Each of these double cardan CV style drive shafts replaces your single U joint drive shaft. Each drive shaft has been pre-balanced and has 3 zerk fittings for ease of lubricating. This ready to go drive shaft is a must... Read More Learn More