Search results for: '2008 jeep wrangler x'

Rubicon Express Rear CV Driveshaft T-Case Adapter Flange 2007+ Jeep Wrangler JK 2 Door & Unlimited 4 Door Billet aluminum flange 8mm-1.25 x 25mm socket cap screws Rear transfer case flange adapter. Must be used with the following drive shaft part numbers: #RE1887-240 (2-door) and RE1887-430 (4-door). Learn More

The Teraflex High-Angle Rzeppa CV Conversion Yoke allows you to convert U-joint style yokes to accept a Rzeppa style CV driveshaft. Learn More

Jeep JK2 and JK4 Front and Rear Rebuild Kit 2007-18 Stock Jeeps use 1 Joint on the Front Driveshaft at the transfer case; 2 Joints on the Rear Driveshaft. Learn More

Driveshaft, Rear, 4sp Auto Trans Learn More

This steel CV rear driveshaft from Rugged Ridge helps to reduce vibration and the driveline angle Learn More

Will only work on cut and tap flange style slip yoke eliminator 1310 series yoke Spicer drive shafts and components are as good as they get. This drive shaft is compatible with the RE1807, RE1801 Slip yoke eliminator kits and Currie Enterprises tail shaft conversion kits. Measurements are taken from flange face to center of the rear u-joint with the slip stub at the center of it's travel. measure your vehicle on the ground in the running position to get correct length. Fits These Vehicles:... Read More Learn More

The Heavy Duty Rear Driveshaft is a tremendous upgrade over stock, increasing strength and providing the features you need for lifted applications. Learn More

1997-06 TJ Wrangler Use only with slip-yoke eliminator kit. 2-6" of Lift 18" extended and 14" collapsed Reduce or eliminate driveline vibration with a CV-equipped drive shaft. Constant Velocity (CV) joints use two U-joints (double cardan style) in the place of a single U-joint. This smoothes out the driveline angle and reduces vibration due to extreme lifts or driveline changes. Learn More

1997-06 TJ Wrangler Bare Steel Fits 3.5 - 6" lift for Mega Short SYE ONLY CV Style Custom designed drive shaft for use with our Mega Short Slip Yoke Eliminator kit. Works in combination with the Mega Short SYE on 97-06 Jeep Wranglers with a suspension lift of 3.5"to 6". Each of these double cardan CV style drive shafts replaces your single U joint drive shaft. Each drive shaft has been pre-balanced and has 3 zerk fittings for ease of lubricating. This ready to go drive shaft is a must... Read More Learn More

CJ REAR DRIVE SHAFTS 1976-79 CJ5 6 OR 8 CYL T150, Collapsed Length: 18.25 ” Alternate Part # 5356509 Learn More