Search results for: '2013 jeep wrangler sahara oe fog light'

Jeep JK2 and JK4 Front and Rear Rebuild Kit 2007-18 Stock Jeeps use 1 Joint on the Front Driveshaft at the transfer case; 2 Joints on the Rear Driveshaft. Learn More

This steel CV rear driveshaft from Rugged Ridge helps to reduce vibration and the driveline angle Learn More

Will only work on cut and tap flange style slip yoke eliminator 1310 series yoke Spicer drive shafts and components are as good as they get. This drive shaft is compatible with the RE1807, RE1801 Slip yoke eliminator kits and Currie Enterprises tail shaft conversion kits. Measurements are taken from flange face to center of the rear u-joint with the slip stub at the center of it's travel. measure your vehicle on the ground in the running position to get correct length. Fits These Vehicles:... Read More Learn More

1997-06 TJ Wrangler Use only with slip-yoke eliminator kit. 2-6" of Lift 18" extended and 14" collapsed Reduce or eliminate driveline vibration with a CV-equipped drive shaft. Constant Velocity (CV) joints use two U-joints (double cardan style) in the place of a single U-joint. This smoothes out the driveline angle and reduces vibration due to extreme lifts or driveline changes. Learn More

1997-06 TJ Wrangler Bare Steel Fits 3.5 - 6" lift for Mega Short SYE ONLY CV Style Custom designed drive shaft for use with our Mega Short Slip Yoke Eliminator kit. Works in combination with the Mega Short SYE on 97-06 Jeep Wranglers with a suspension lift of 3.5"to 6". Each of these double cardan CV style drive shafts replaces your single U joint drive shaft. Each drive shaft has been pre-balanced and has 3 zerk fittings for ease of lubricating. This ready to go drive shaft is a must... Read More Learn More

CJ REAR DRIVE SHAFTS 1976-79 CJ5 6 OR 8 CYL T150, Collapsed Length: 18.25 ” Alternate Part # 5356509 Learn More

This double cardan style CV drive shaft is recommended for Jeep XJ Cherokee models equipped with 4in - 6in suspension lifts to prevent driveline vibration and the rear output shaft from breaking. Learn More

You are buying a Rear XJ Cherokee 1310 [Extreme Duty Series] CV Driveshaft made by Adams Driveshaft the Industry Leader in Custom Driveshafts. Learn More

This stock replacement rear driveshaft from Omix fits 1980 Jeep CJ7 with a SR4 or T170 manual transmission. Learn More

1981 CJ5 4 OR 6 CYL SR4; 1982-86 CJ5 4 OR 6 CYL T4 OR T5; REAR DRIVE SHAFT, Collapsed Length: 13 ” Alternate Part # 5362276 Learn More