Search results for: 'jeep kit'

Replace or repair your used FlexArm bushings and sleeves. This kit is designed to repair one arm. Bushings are made from polyurethane, and sleeves are steel. Details: Lower FlexArm Includes Bushings and Sleeves Each Learn More

Upgrade your stock steering system with the TeraFlex TJ: High Steer HD Aluminum Drag Link Kit. The High Steer HD Aluminum Drag Link and Tie Rod (NOT INCLUDED) can be used to convert the TJ’s stock steering to a cross steering or a flipped steering setup. Learn More

Front Lower Control Arm Cam Bolt Kit: Includes Cam Bolt, Cam Washer and Nut; M14 x 2.0 x 111mm Cam Bolt. Offers Plus or Minus 3 Degrees of Caster / Pinion Angle. Learn More

Power Stop brake kits include a complete set of cross-drilled and slotted rotors and high performance Evolution Sport Carbon Fiber/Ceramic pads. Learn More

Improve exhaust flow with RT Off-Road's Stainless Steel Header Kit for 4.0L Jeep vehicles. Learn More

The Crown Automotive Rough Trail™ Disc Brake Conversion is for the Jeep owner that wants a little more response in the brake pedal and more confidence in stopping power. Learn More

These great kits offer all the components you will need to complete your differential rebuild or ring & pinion installation. Complete with bearings, pinion seals, pinion shims, crush sleeve, pinion nut, ring gear bolts and marking compound. Original Alloy USA Part 352031 Learn More

Yukon Gear and Axle understands that sometimes you only need minimal parts to service your Jeeps Dana 35 Axle. Learn More

Will only work on cut and tap flange style slip yoke eliminator 1310 series yoke Spicer drive shafts and components are as good as they get. This drive shaft is compatible with the RE1807, RE1801 Slip yoke eliminator kits and Currie Enterprises tail shaft conversion kits. Measurements are taken from flange face to center of the rear u-joint with the slip stub at the center of it's travel. measure your vehicle on the ground in the running position to get correct length. Fits These Vehicles:... Read More Learn More

VIAIR's 90 Series compressors offer a light duty solution for smaller air requirements and are meant to fill no larger than a 1.0 gallon air tank. Multiple duty cycle, mounting, compressor finish and intake options are available depending on model. Included Parts: - Omega Bracket - Check Valve - Vibration Isolators - Mounting Hardware - Installation Instructions Specifications - 12-Volt - Permanent Magnetic Motor - Duty Cycle: 9% @ 100 PSI - Max. Working Pressure: 120 PSI - Max. Air Tank... Read More Learn More