Search results for: 'jeep commander rough coun'

Rear Frame Crossmember, Located in Front of Rear Bumper. Learn More

Replace that rusted out original with this heavy-duty weldin unit. Factory installed rubber mounts between the body and the rear crossmember accelerate the corrosion process, our heavy-duty unit is the perfect solution. This crossmember ties the two frame rails together and supports the rear of the body and the bumper mounts. Precision CNC cut from heavy gauge steel, meeting or surpassing factory specifications. Learn More

SafeTCap ART-135 Front Steering Box Mount is designed as an OEM spec replacement. It is made from 11 gage steel and comes with two crush tubes, similar to the original. Our steering box mount also includes our signature SafeTCap drain hole. The ART-135 is CNC cut, bent and MIG welded by our AWS certified Welders in our USA facility. This part will be installed by welding it to the frame in the footprint of the original after the old mount has been removed and frame ground down to clean... Read More Learn More

The Full-Length Torque Box & Floor Support for 1997-2006 Jeep Wrangler corrodes over time from exposure to elements both on and off road. Learn More

This is a replacement part for the area where the frame and body are bolted together. This part covers only the center (middle) mounting point and includes the body mount bolt and nut welded in place. It measures 16 inches in length and comes with detailed installation instructions. Learn More

Our SafeTCap® ART-135-1-R Front Frame Section was designed to cap over the passenger side original frame after removing the rotted metal, then welding the new frame repair section to the frame. Learn More

Our ART-145-2 SafeTCap® frame repair kit is a shorter version of our ART-145. It was designed as a faster, easier, and more cost effective solution for your rusted, damaged floor support/torque box. This frame kit repairs the 2 rear body mounts on the Passenger side floor support/torque box and is made from 13 gage American steel, and is CNC cut and bent for a perfect fit every time. Our ART-145-2 frame kit is designed to cap the existing floor support/torque box after the frame mounting... Read More Learn More

Our SafeTCap ART-163 Front Upper Trailing Arm mount is designed to repair rusted out or damaged front upper Trailing arm mount brackets on the 1997-2006 Jeep Wrangler, both TJ and LJ models. The ART-163 is designed to be an OEM replacement and has been upgraded using heavy duty 7 gauge steel. A new front upper trailing arm mounting bolt and factory installed weld nut is included with the bracket. To install this kit follow our step by step instructions to cut and remove your old bracket and... Read More Learn More

Our ART-145 was designed to repair the full length floor support/torque box by capping over the original. It covers all three mounting points and includes high grade body mount bolts and nuts welded in place for each mount. You will need to remove the mounting points where the frame and body are bolted together. Comes with detailed installation instructions. Learn More

Our SafeTCap® ART-143 Rear Lower Coil spring mount was designed as a direct replacement for your Jeep Wrangler TJ and LJ original rear lower coil spring mount on the rear axle. This part should be welded onto the rear axle once the original spring mount is removed and the axle is ground down to clean metal. Our ART-143 is made from 7 gage steel and is CNC cut, bent and assembled by our AWS certified welders in the USA. This part is sold individually and is designed to fit both Driver and... Read More Learn More