Search results for: '2013 jeep grand cherokee 2 inch suspension li'

This double cardan style CV drive shaft is recommended for Jeep XJ Cherokee models equipped with 4in - 6in suspension lifts to prevent driveline vibration and the rear output shaft from breaking. Learn More

Will only work on fixed yoke style slip yoke eliminator 1310 series yoke Spicer drive shafts and components are as good as they get. This drive shaft is compatible with the RE1811 Slip yoke eliminator kit, Atlas transfer cases and any other 1310 series CV yoke. Measurements are taken center to center on the u-joint with the slip stub at the center of it's travel. measure your vehicle on the ground in the running position to get correct length. Fits These Vehicles: 87-95 Jeep Wrangler... Read More Learn More

Will only work on cut and tap flange style slip yoke eliminator 1310 series yoke Spicer drive shafts and components are as good as they get. This drive shaft is compatible with the RE1807, RE1801 Slip yoke eliminator kits and Currie Enterprises tail shaft conversion kits. Measurements are taken from flange face to center of the rear u-joint with the slip stub at the center of it's travel. measure your vehicle on the ground in the running position to get correct length. Fits These Vehicles:... Read More Learn More

2007-15 JK Wrangler and Rubicon 2-Door Double-Cardan joint Direct bolt on drive shaft Extended Length = 22.50" Compressed Length = 26.50" 1310 U-joints New original equipment JK Wranglers use drive shafts that have Rzeppa CV joints similar to most front wheel drive cars. These CV joints are fine for normal car applications but when you lift your Jeep or put on larger tires and drive your Jeep off road, these joints are not up to the task! Rugged Ridge has developed a solution for this... Read More Learn More

Rough Country CV Drive Shaft Rear For 2007-11 Jeep Wrangler JK 2 Door (With 3½-6" Lift) Collapsed Measurement: 23.875-inches Extended Measurement: 27.375-inches Learn More

Rough Country CV Drive Shaft Rear For 2012-18 Jeep Wrangler JK 2 Door (With 3½-6" Lift) Collapsed Measurement: 22.875-inches Extended Measurement: 26.375-inches Learn More

The Teraflex High-Angle Rzeppa CV Conversion Yoke allows you to convert U-joint style yokes to accept a Rzeppa style CV driveshaft. Learn More

The Teraflex High-Angle Rzeppa CV Conversion Yoke allows you to convert U-joint style yokes to accept a Rzeppa style CV driveshaft. Used for Front Driveshaft replacement when using Teraflex Rzeppa Driveshaft. Learn More

Rubicon Express Rear CV Driveshaft T-Case Adapter Flange 2007+ Jeep Wrangler JK 2 Door & Unlimited 4 Door Billet aluminum flange 8mm-1.25 x 25mm socket cap screws Rear transfer case flange adapter. Must be used with the following drive shaft part numbers: #RE1887-240 (2-door) and RE1887-430 (4-door). Learn More

Driveshaft, Rear, 4sp Auto Trans Learn More