Driveshaft - Rear

This double cardan style CV drive shaft is recommended for Jeep TJ Wrangler models equipped with 4in - 6in suspension lifts or 87-93 Jeep YJ Wrangler models equipped with 4in suspension lifts to prevent driveline vibration and the rear output shaft from breaking. Learn More

Rough Country CV Drive Shaft Rear For 1997-06 Jeep Wranler TJ Non Rubicon (With 6cyl, Dana 35 & 44, 4" Lift -16.00) Learn More

Rough Country CV Drive Shaft Rear For 2003-06 Jeep Wrangler TJ Rubicon (With 4-6" Lift) Measurement: 16.875-inches - 20.125-inches (18.5 Running Length) Learn More

Rear Driveshaft Assembly For 2001-05 Jeep Wrangler 2.5L 4 Cylinder Alternate Part # 52098784AC Learn More

1997-06 TJ Wrangler Use only with slip-yoke eliminator kit. 2-6" of Lift 18" extended and 14" collapsed Reduce or eliminate driveline vibration with a CV-equipped drive shaft. Constant Velocity (CV) joints use two U-joints (double cardan style) in the place of a single U-joint. This smoothes out the driveline angle and reduces vibration due to extreme lifts or driveline changes. Learn More

Rough Country CV Drive Shaft Rear For 2000-06 Jeep Wranler TJ Non Rubicon (With 6cyl, Dana 44, Manual Trans & 4" Lift -16.75) Learn More

Rear Driveshaft Assembly For 2003-06 Jeep Wrangler with Dana 35 And 4cyl Manual Alternate Part # 52853407AA Learn More

Rough Country CV Drive Shaft Rear For 1987-93 Jeep Wrangler YJ & TJ 1997-06 4cyl Wrangler With 4" Lift -17.25") Learn More

Will only work on fixed yoke style slip yoke eliminator 1310 series yoke Spicer drive shafts and components are as good as they get. This drive shaft is compatible with the RE1811 Slip yoke eliminator kit, Atlas transfer cases and any other 1310 series CV yoke. Measurements are taken center to center on the u-joint with the slip stub at the center of it's travel. measure your vehicle on the ground in the running position to get correct length. Fits These Vehicles: 87-95 Jeep Wrangler... Read More Learn More

1997-06 TJ Wrangler Bare Steel Fits 3.5 - 6" lift for Mega Short SYE ONLY CV Style Custom designed drive shaft for use with our Mega Short Slip Yoke Eliminator kit. Works in combination with the Mega Short SYE on 97-06 Jeep Wranglers with a suspension lift of 3.5"to 6". Each of these double cardan CV style drive shafts replaces your single U joint drive shaft. Each drive shaft has been pre-balanced and has 3 zerk fittings for ease of lubricating. This ready to go drive shaft is a must... Read More Learn More