Jeep Part Sales

The CJ’s rear leaf spring mounting point has a factory rubber body mount above it that often leads to deterioration of the frame area. Over time, moisture gets trapped around the leaf spring bushings while dirt and debris get trapped inside the frame rails causing severe rust-through. Cut out the old mount and cut back the rust, then cover with the Safe-T-CapTM and weld in place – you’re back on the road without an expensive full frame replacement. You will need to buy new leaf spring... Read More Learn More

The CJ’s rear leaf spring mounting point has a factory rubber body mount above it that often leads to deterioration of the frame area. Over time, moisture gets trapped around the leaf spring bushings while dirt and debris get trapped inside the frame rails causing severe rust-through. Cut out the old mount and cut back the rust, then cover with the Safe-T-CapTM and weld in place – you’re back on the road without an expensive full frame replacement. You will need to buy new leaf spring... Read More Learn More

Description: Front trailing arm mounts are located in this area. The boxed frame allows dirt and moisture to collect inside the frame, allowing it to rust from the inside out. This repair kit is heavy gauge steel, CNC cut, bent and precision welded. This part will help improve Safety got you and your jeep. Learn More

Replace that rusted out original with this heavy-duty weldin unit. Factory installed rubber mounts between the body and the rear crossmember accelerate the corrosion process, our heavy-duty unit is the perfect solution. This crossmember ties the two frame rails together and supports the rear of the body and the bumper mounts. Precision CNC cut from heavy gauge steel, meeting or surpassing factory specifications. Learn More

Learn More

Learn More

SafeTCap ART-142-L is designed to be a direct replacement for the original rear upper coil spring mount on your Jeep TJ and LJ. The spring plate and the frame mount bracket are made from 11 gage cold rolled steel. There is a pre welded 2.5″ long bump stop mount tube included with an m10-1.5 weld nut. The attached frame mount bracket is made to slip over the frame after removing the old spring mount. Learn More

Our SafeTCap® ART-143 Rear Lower Coil spring mount was designed as a direct replacement for your Jeep Wrangler TJ and LJ original rear lower coil spring mount on the rear axle. This part should be welded onto the rear axle once the original spring mount is removed and the axle is ground down to clean metal. Our ART-143 is made from 7 gage steel and is CNC cut, bent and assembled by our AWS certified welders in the USA. This part is sold individually and is designed to fit both Driver and... Read More Learn More

Our ART-175 SafeTCap kit is designed to repair the area on the 97-02 TJ transmission skid plate that is bolted to the frame. We’ve installed hundreds of our center frame repair kits and most all of the skid plates were rusted and deteriorated where they are bolted to the frame, making it impossible to remount. So, instead of buying a new or aftermarket skid plate which costs hundreds of dollars, we’ve created a cost effective solution to this problem. Our Skid plate repair kit is CNC cut... Read More Learn More

Finally! We are manufacturing the center gas tank support. This critical frame component collects and traps an abundance of dirt and road debris, and can be a disaster if it fails. Learn More