Jeep Part Sales

Our Safe-T-Cap frame repair kit is designed for a severely rusted frame on the TJ Wrangler. Learn More

Our SafeTCap® ART-135-1-S Front Frame Section was designed to cap over the original frame after removing the steering box mount and rotted metal then welding the new frame repair section to the frame. Learn More

Over time, moisture, dirt and debris gets trapped inside the frame rails causing severe rust through. These are full replacement sections that recreate complete new sections with no metal fabrication required. Learn More

Description: Front trailing arm mounts are located in this area. The boxed frame allows dirt and moisture to collect inside the frame, allowing it to rust from the inside out. This repair kit is heavy gauge steel, CNC cut, bent and precision welded. This part will help improve Safety got you and your jeep. Learn More

Rear Upper Trailing Arm Mount Replacement, Right (Passenger) Side. Fits 1997-2006 Jeep Wrangler TJ. This replacement mount is made from Heavy Duty 7 Gauge Steel, CNC Cut and Welded by our Certified Welders! The original factory mount is made from thinner material, making it susceptible to rusting out and tearing away from the frame. The part includes a new high grade bolt and nut welded in place. Learn More

Our Safe-T-Cap frame repair kit is designed for a severely rusted frame on the TJ Wrangler. We have found that the frame starts to rust from the inside out, and can create an unsafe condition. Learn More

SafeTCap ART-135 Front Steering Box Mount is designed as an OEM spec replacement. It is made from 11 gage steel and comes with two crush tubes, similar to the original. Our steering box mount also includes our signature SafeTCap drain hole. The ART-135 is CNC cut, bent and MIG welded by our AWS certified Welders in our USA facility. This part will be installed by welding it to the frame in the footprint of the original after the old mount has been removed and frame ground down to clean... Read More Learn More

Our ART-145 was designed to repair the full length floor support/torque box by capping over the original. It covers all three mounting points and includes high grade body mount bolts and nuts welded in place for each mount. You will need to remove the mounting points where the frame and body are bolted together. Comes with detailed installation instructions. Learn More

Our Safe-T-Cap frame repair kit is designed for a severely rusted frame on the TJ Wrangler. We have found that the frame starts to rust from the inside out, and can create an unsafe condition. Learn More

SafeTCap ART-142-R is designed to be a direct replacement for the original rear upper coil spring mount on your Jeep TJ and LJ. The spring plate and the frame mount bracket are made from 11 gage cold rolled steel. There is a pre welded 2.5″ long bump stop mount tube included with an m10-1.5 weld nut. The attached frame mount bracket is made to slip over the frame after removing the old spring mount. Learn More