Jeep Part Sales

Replacement TeraFlex TJ: Track Bar Joint. Right-hand thread. Features a forged zinc plated housing with a small rubber bushing as well as an additional rate for superior stiffness. Learn More

The TeraFlex VSS™ Gas Shock uses a twin tube design, triple-chrome plated rod to ensure extended trouble-free operation. Sold individually. You will find premium quality rubber bushings with the attachments for the TJ and a resistant black finish that will withstand a lot of off-road abuse. Details: Front shock 3-4" lift Triple-chromed rods Learn More

The TeraFlex Rear Wide CRD60 Full-Float Axle Housing with Pro LCG Truss is a direct bolt-on upgrade for TJ Wrangler owners looking to replacing weakened, strained, or damaged stock rear axle in TJ Wrangler and Rubicon vehicles. Learn More

TeraFlex Heavy Duty ball joints are engineered to handle the increased load caused by oversized tires and offset wheels. Learn More

It provides improvements in off road performance while maintaining a quality highway ride. The kit includes springs, rear sway bar links, rear track bar bracket, bump stops and all necessary hardware required for installation. • Max Tire Diameter: 33” Learn More

We have designed our front coil springs to eliminate this factory rake. This means that a lift kit after installation when measured & compared to factory measurements will be lifted more in the front than the rear, to level out the vehicle. In addition, we estimate that additional aftermarket components will be added to the vehicle (such as a winch, bumpers, racks and larger spare tire). We attempt to have our suspensions sit at or close to the advertised lift height with all of the aftermarket... Read More Learn More

This TJ / YJ / XJ 231 Short Shaft Kit increases the rear driveshaft length by 4 inches, which eliminates the need for a Transfer Case Lowering Kit in most cases. Also includes a larger output bearing and rear housing. Learn More

TeraFlex Coil Spring Spacers are perfect to level your jeep from sagging or from extra weight caused by heavy loads or accessories. Learn More

The brake light extension is designed to allow the use of a larger full size spare tire and retain the factory third brake light for safety. The extension is designed as a complete bolt-on accessory with no drilling required. It will accommodate tires up to 33". If the tire is mounted on a wider aftermarket wheel and tire combination with additional offset than factory, a tire extension must be used (Part # 1907200). Details: Black powder coat TeraFlex 3rd brake light extender bracket Learn More

These bumpstops extend your factory bump stop pad to control the front suspension compression so your large tires wont damage your fenders. Details: 2.25 in. tall 2 in. O.D. Learn More