Jeep Part Sales

Place your air source just about anywhere you want it with this relocation kit from VIAIR. Included Parts: - 1/4" NPT (F) Quick Connect Coupler - 1/4" NPT (F) Quick Connect Stud - (2) 1/4" NPT Compression Fittings (For 1/4" Line) - 15 ft. Air Line Tubing - 3 Air Line Clips - 5" Continuous Grommet Learn More

Pressure Switches with Built-in Relay - are heavy duty and moisture resistant. They’re been tested to last 10,000+ cycles. They measure 4.25”L x 2.25”W and come with 1/8” male port fittings. Leads are pre-fitted with insulated 1/4” male push-to-connect terminals that are clearly marked for simple installation. 1/8" NPT Male Port 85 PSI On, 105 PSI Off Learn More

Poison Spyder Bombshell Diff Covers are designed to protect your gears, lockers and diff cover bolts from the most punishing rocks and trail hazards. The stock covers your Jeep came with are weak, stamped sheetmetal. Even a moderate tap with a rock can cave it in against your ring gear, causing potential damage to the gears, locker and carrier bearings, not to mention a difficult, messy trail fix. Even more common, though less catastrophic, is "peel back" that can occur when sliding over a rock... Read More Learn More

G2 Axle and Gear Chromoly Inner Axle Shaft Dana 44 Dana 44 JK 30 Spline Stock Overall Length Accepts 5-7166X U-Joint Passenger Side Machined to Accept Full Circle Clips For Use In 2007 Up Learn More

Raised Front Track Bar Bracket For 2007+ Jeep Wrangler JK 2 Door & Unlimited 4 Door Models Heavy-duty steel construction Unpainted Adjusts factory track bar mounting location for lifted applications Welding required The all new G2 Heavy Duty JK Dana 30 and Dana 44 Raised Height Track Bar Bracket gives your axle the strength it needs to tackle the hardest trails. Formed from laser cut 1/4" thick steel, this bracket is designed to give a precision fit, ensuring trouble-free installation.... Read More Learn More

Weld On Rear Coil Buckets For 2007+ Jeep Wrangler JK 2 Door & Unlimited 4 Door Models With Dana 44 Axle Assembly Rear coil buckets for 68-2052-1 Heavy-duty steel construction Unpainted Welding-required The all new G2 Heavy Duty JK Rear Dana 44 heavy duty coil buckets are designed to be used with the G2 rear axle truss and armor system to give your JK the strength it needs to take serious abuse. Constructed from 1/4" thick main components and 1/8" thick reinforcement plates, all... Read More Learn More

Aluminum Differential Cover Black Powdercoated For Dana 30 Axle Assemblies Cast From Lighweight Aluminum to Disipate Heat Reinforcing Ribs for Added Rigidity and Strength Heat Treated and Shot Peened to Handle Direct Impact Fully Machined Seal Surface for a Leak Free Installation Black Powder Coated Learn More

These all-inclusive TeraFlex Sport ST (Street & Trail) Suspensions Systems deliver true street & trail (ST) performance and capability in a dependable and maintenance-free package. Learn More

Improve your ride and reduce wear on your driveline with the Front Full Float 8-Lug Locking Hub Conversion Kit with Rotors from TeraFlex. Dana 30/44 Front Learn More

The factory rear JK axle and wheel bearing assembly naturally lends itself to bent axle shafts. Learn More