Rugged Ridge Front CV Drive Shaft (0-2" Lift) For 2007-18 Jeep Wrangler JK 2 Door & Unlimited 4 Door Models 16592.22
SKU
RR-16592.22
We Price Match
- Part: Driveshaft - Front
- Manufacturer: Rugged Ridge
Front Driveshaft
Extended Length = 36" / Compressed Length = 32" / Running Length 34"
Extended Length = 36" / Compressed Length = 32" / Running Length 34"
Special Price $934.11 Regular Price $1,098.95
Rugged Ridge 16592.22
Double-Cardan joint
Direct bolt on drive shaft
Extended Length = 36"
Compressed Length = 32"
New original equipment JK Wranglers use drive shafts that have Rzeppa CV joints similar to most front wheel drive cars. These CV joints are fine for normal car applications but when you lift your Jeep or put on larger tires and drive your Jeep off road, these joints are not up to the task! Rugged Ridge has developed a solution for this problem with double–Cardan Joint drive shafts for the JK Wrangler. These double U-joints provide better strength and operating angle and reduce vibration on lifted Jeeps.
Each drive shaft has increased tube thickness and standard slip yokes for long life and easy of installation.
All U-joint s are Spicer Brand.
Double-Cardan joint
Direct bolt on drive shaft
Extended Length = 36"
Compressed Length = 32"
New original equipment JK Wranglers use drive shafts that have Rzeppa CV joints similar to most front wheel drive cars. These CV joints are fine for normal car applications but when you lift your Jeep or put on larger tires and drive your Jeep off road, these joints are not up to the task! Rugged Ridge has developed a solution for this problem with double–Cardan Joint drive shafts for the JK Wrangler. These double U-joints provide better strength and operating angle and reduce vibration on lifted Jeeps.
Each drive shaft has increased tube thickness and standard slip yokes for long life and easy of installation.
All U-joint s are Spicer Brand.
Notes:
Due to Jeep changing their angles on the JT and JL Models, if you install an Aftermarket Differential or Axle Kit that Eliminates the [FAD] front axle disconnect and the driveshaft spins full-time, it may result in a vibration and/or premature U-joint and CV failure due to angles.
Not for 392 MODELS since they are Non-FAD. Requires Front Adjustable Control Arms to adjust the Pinion Angles.
Not for 4xE Models that use longer Driveshafts.
| Searchable Sku | 16592.22 |
|---|---|
| Bulk Item Surcharge | $0.00 |
| Manufacturer | Rugged Ridge |
Write Your Own Review
