TeraFlex

We have designed our front coil springs to eliminate this factory rake. This means that a lift kit after installation when measured & compared to factory measurements will be lifted more in the front than the rear, to level out the vehicle. In addition, we estimate that additional aftermarket components will be added to the vehicle (such as a winch, bumpers, racks and larger spare tire). We attempt to have our suspensions sit at or close to the advertised lift height with all of the aftermarket... Read More Learn More

This TJ / YJ / XJ 231 Short Shaft Kit increases the rear driveshaft length by 4 inches, which eliminates the need for a Transfer Case Lowering Kit in most cases. Also includes a larger output bearing and rear housing. Learn More

TeraFlex Coil Spring Spacers are perfect to level your jeep from sagging or from extra weight caused by heavy loads or accessories. Learn More

The brake light extension is designed to allow the use of a larger full size spare tire and retain the factory third brake light for safety. The extension is designed as a complete bolt-on accessory with no drilling required. It will accommodate tires up to 33". If the tire is mounted on a wider aftermarket wheel and tire combination with additional offset than factory, a tire extension must be used (Part # 1907200). Details: Black powder coat TeraFlex 3rd brake light extender bracket Learn More

These bumpstops extend your factory bump stop pad to control the front suspension compression so your large tires wont damage your fenders. Details: 2.25 in. tall 2 in. O.D. Learn More

TeraFlex TJ: Lift Coil Springs are perfectly engineered for your TJ Jeep Wrangler/Unlimited. Our Lift Coil Springs deliver unsurpassed highway handling and off-road performance. Learn More

TeraFlex LCG (Low Center-of-Gravity) Long Arm Suspension Systems are engineered for hardcore Jeepers who don’t want to give up on-road comfort and control in their TJ Wrangler/Unlimited. These complete systems include all necessary components including LCG Long Arm Brackets. Learn More

A shift linkage kit may be necessary to properly locate your transfer case linkage when a body lift is used on TJ Wranglers. Details: NP231 transfer case For use with body lifts or transfer case drops Learn More

The TeraFlex TJ disc brake hose kit is required when installing a rear disc brake conversion kit on a TJ Wrangler. This hose kit connects the disc brake kit to the hard brake line mounted to the axle. This kit includes two flexible brake hoses, two brake clips, two banjo bolts, 4 copper washers, and two brake line mounting brackets. Details: Includes brackets and hardware Fits Teraflex disc brake kit Includes: Flex Lines Line Mounts Banjo Bolts Banjo Washers Installation Hardware Learn More

TJ Front and Rear Axle Lower FlexArm Mount- Driver Details: FlexArm Mount Driver Side Front Lower Learn More