Auto Rust Technicians

Our ART-145-2 SafeTCap® frame repair kit is a shorter version of our ART-145. It was designed as a faster, easier, and more cost effective solution for your rusted, damaged floor support/torque box. This frame kit repairs the 2 rear body mounts on the Passenger side floor support/torque box and is made from 13 gage American steel, and is CNC cut and bent for a perfect fit every time. Our ART-145-2 frame kit is designed to cap the existing floor support/torque box after the frame mounting... Read More Learn More

SafeTCap ART-135 Front Steering Box Mount is designed as an OEM spec replacement. It is made from 11 gage steel and comes with two crush tubes, similar to the original. Our steering box mount also includes our signature SafeTCap drain hole. The ART-135 is CNC cut, bent and MIG welded by our AWS certified Welders in our USA facility. This part will be installed by welding it to the frame in the footprint of the original after the old mount has been removed and frame ground down to clean... Read More Learn More

Our ART-145 was designed to repair the full length floor support/torque box by capping over the original. It covers all three mounting points and includes high grade body mount bolts and nuts welded in place for each mount. You will need to remove the mounting points where the frame and body are bolted together. Comes with detailed installation instructions. Learn More

Our Safe-T-Cap frame repair kit is designed for a severely rusted frame on the TJ Wrangler. We have found that the frame starts to rust from the inside out, and can create an unsafe condition. Learn More

SafeTCap ART-142-R is designed to be a direct replacement for the original rear upper coil spring mount on your Jeep TJ and LJ. The spring plate and the frame mount bracket are made from 11 gage cold rolled steel. There is a pre welded 2.5″ long bump stop mount tube included with an m10-1.5 weld nut. The attached frame mount bracket is made to slip over the frame after removing the old spring mount. Learn More

This is a replacement part for the area where the frame and body are bolted together. This part covers only the center (middle) mounting point and includes the body mount bolt and nut welded in place. It measures 16 inches in length and comes with detailed installation instructions. Learn More

Our SafeTCap ART-163 Front Upper Trailing Arm mount is designed to repair rusted out or damaged front upper Trailing arm mount brackets on the 1997-2006 Jeep Wrangler, both TJ and LJ models. The ART-163 is designed to be an OEM replacement and has been upgraded using heavy duty 7 gauge steel. A new front upper trailing arm mounting bolt and factory installed weld nut is included with the bracket. To install this kit follow our step by step instructions to cut and remove your old bracket and... Read More Learn More