Omix-ADA Front Drive Shaft For 1997-06 TJ Wrangler (Non-Rubicon) 16590.24
SKU
OA-16590.24
We Price Match
- Part: Driveshaft - Front
- Manufacturer: OMIX-ADA
Fits:
Jeep Wrangler (TJ) (2003-2006) w/ 4.0L engine; without Rubicon Package.
Jeep Wrangler (TJ) (1997-2002) w/ 4.0L engine; w/ Manual Transmission.
Length collapsed is 37 inches and extended is 40 inches form center of u-joint to center of u-joint.
Jeep Wrangler (TJ) (2003-2006) w/ 4.0L engine; without Rubicon Package.
Jeep Wrangler (TJ) (1997-2002) w/ 4.0L engine; w/ Manual Transmission.
Length collapsed is 37 inches and extended is 40 inches form center of u-joint to center of u-joint.
Special Price $672.31 Regular Price $790.95
OMIX-ADA 16590.24
Fits:
Jeep Wrangler (TJ) (2003-2006) w/ 4.0L engine; without Rubicon Package.
Jeep Wrangler (TJ) (1997-2002) w/ 4.0L engine; w/ Manual Transmission.
Length collapsed is 37 inches and extended is 40 inches form center of u-joint to center of u-joint
Alternate Part # 52098377AE
Fits:
Jeep Wrangler (TJ) (2003-2006) w/ 4.0L engine; without Rubicon Package.
Jeep Wrangler (TJ) (1997-2002) w/ 4.0L engine; w/ Manual Transmission.
Length collapsed is 37 inches and extended is 40 inches form center of u-joint to center of u-joint
Alternate Part # 52098377AE
Important Note: This does not fit Rubicon Models
Notes:
Due to Jeep changing their angles on the JT and JL Models, if you install an Aftermarket Differential or Axle Kit that Eliminates the [FAD] front axle disconnect and the driveshaft spins full-time, it may result in a vibration and/or premature U-joint and CV failure due to angles.
Not for 392 MODELS since they are Non-FAD. Requires Front Adjustable Control Arms to adjust the Pinion Angles.
Not for 4xE Models that use longer Driveshafts.
| Searchable Sku | 16590.24 |
|---|---|
| Bulk Item Surcharge | $0.00 |
| Manufacturer | OMIX-ADA |
Write Your Own Review
