Frame - Restoration Parts

Our SafeTCap ART-136 is a replacement for the OEM rear track bar bracket on the Jeep Wrangler TJ. The bracket is made from 7 gauge HRPO steel, CNC cut, bent and MIG welded in the USA facility. The hardware to remount the track bar is included with the bracket. To install this part you will need to disconnect the track bar and you simply cut off the old mount and weld the new mount in the footprint of the old mount. ATTENTION: The SafeTCap ART-136 is designed as an OEM replacement and is not... Read More Learn More

Our ART-124LJ frame repair kit is designed to slip over your stock frame, while maintaining factory dimensions and mounting points. Learn More

Our SafeTCap® ART-135-1-R Front Frame Section was designed to cap over the passenger side original frame after removing the rotted metal, then welding the new frame repair section to the frame. Learn More

Finally! We are manufacturing the center gas tank support. This critical frame component collects and traps an abundance of dirt and road debris, and can be a disaster if it fails. Learn More

Wranglers have weld-nuts inside the frame rails that secure the transfer case skid plate in place. The skid plate also is the transmission and transfer case mount. Typically the bolts are a problem to remove due to rust on the inside of the frame rail. When this happens, access holes are often cut unto the side to facilitate removal of these bolts. This method gives access to dirt and water, which can collect inside the rails and rust them from the inside out. This Safe-T-CapTM kit is a... Read More Learn More

On YJs there is a factory body mount right above the frame at the forward rear leaf spring mounting point. The rubber bushing gets old and cracks, attracting moisture, dirt... and rust. Frame deterioration is a very common problem in this critical suspension mounting point. This unit includes the frame mount and the spring shackle mount. You will need to buy new leaf spring mount bushings for best results. This is a Safe-T-CapTM section that fixes the problem – we make it easy to... Read More Learn More

The CJ’s rear leaf spring mounting point has a factory rubber body mount above it that often leads to deterioration of the frame area. Over time, moisture gets trapped around the leaf spring bushings while dirt and debris get trapped inside the frame rails causing severe rust-through. Cut out the old mount and cut back the rust, then cover with the Safe-T-CapTM and weld in place – you’re back on the road without an expensive full frame replacement. You will need to buy new leaf spring... Read More Learn More

This part is for Right (passenger) side and Fits 1997-2006 Jeep Wrangler TJ. Our kit repairs the rear frame area that ties into the rear crossmember. It is designed to fit over your existing frame after you cut and remove the rotted portions. The part measures 24” long, is made from 11 gauge cold rolled steel, CNC cut and welded by our Certified welders. Learn More

Our SafeTCap® ART-143 Rear Lower Coil spring mount was designed as a direct replacement for your Jeep Wrangler TJ and LJ original rear lower coil spring mount on the rear axle. This part should be welded onto the rear axle once the original spring mount is removed and the axle is ground down to clean metal. Our ART-143 is made from 7 gage steel and is CNC cut, bent and assembled by our AWS certified welders in the USA. This part is sold individually and is designed to fit both Driver and... Read More Learn More

Our ART-175 SafeTCap kit is designed to repair the area on the 97-02 TJ transmission skid plate that is bolted to the frame. We’ve installed hundreds of our center frame repair kits and most all of the skid plates were rusted and deteriorated where they are bolted to the frame, making it impossible to remount. So, instead of buying a new or aftermarket skid plate which costs hundreds of dollars, we’ve created a cost effective solution to this problem. Our Skid plate repair kit is CNC cut... Read More Learn More