TeraFlex

Jeep Vehicles with Vacuum Disconnect Learn More

The 2Low kit provides the benefit of true low range gearing, while allowing the front to freely turn. It lets you choose 2 Low in addition to the other standard options. The 2 Low kit will eliminate drive train bind and most of your three-point turns. This kit is completely internal and does not require any external modifications. Note: Fits 231-J transfer cases only. Details: NP231-J transfer case True low range while allowing the front axle to turn freely Eliminates binding when turning All... Read More Learn More

These tabs make it easy to replace or improve the factory control arm mounts. Sold as 1 single piece. Details: Weld on Fits 3" O.D. tubing 1/4" thick Sold individually Learn More

The TeraFlex hand throttle kit is designed to provide constant idle or speed when off-roading. It is especially useful when use of clutch, gas and brake are needed together. The hand throttle is designed for off-road use only and is not intended to be used as a ‘cruise control’ device. Details: Manual transmission only Off-road use only Learn More

TeraFlex Flex Ends will allow some misalignment when articulating, and have a specially designed urethane bushing to restrict excess movement and allow control and handling at highway speeds. Details: Left hand thread 2-5/8" shoulder width 1-1/4" x 12 TPI shank Accepts 9/16" bolt Learn More

Used as replacement in Teraflex 1615700 Monster Lower FlexArms for 84-06 Jeep Cherokee XJ, Comanche MJ, Grand Cherokee ZJ & WJ, Wrangler TJ & Unlimited Details: Right hand thread 2-5/8" shoulder width 1-1/4" x 12 TPI shank Accepts 9/16" bolt Learn More

When a quiet street ride and vibration free driving are required, the rubber bushing ends will give you the feel you want. The rubber bushing will provide the most noise and vibration dampening characteristics possible. This end can also be used as a replacement for any control arm utilizing a 1-1/4” x 12 tpi. ‘heim’ type rod end. Uses a 9/16” bolt. LEFT Hand Thread. Details: Left hand thread 2-5/8" shoulder width 1-1/4" x 12 TPI shank Accepts 9/16" bolt Learn More

These universal leaf spring mounting plates will allow you to attach leaf springs to custom axles, or to rebuild your stock application. The plates will work with all rear axles, including stock Jeep, Dana 44 & 60. Sold in pairs. Details: Leaf Spring Plates Universal Fit Sold As: Pair Learn More

The angled rod end forging is designed for applications needing additional clearance for tires, or other frame configurations. The end utilizes a 7/8” x 18 tpi. shank and accepts a 9/16” bolt. The TJ Wrangler version features a 2" wide shoulder width while the JK version comes with a standard 2-5/16" shoulder width. Details: Right hand thread 9 degree angle 2-5/16" shoulder width 7/8" x 18 TPI shank Accepts 9/16" bolt Learn More

Rod End Rebuild Kit Medium Rod End rebuild kits include 2 bushings, 1 chrome ball, 1 retaining washer and 1 snap ring. A rebuild tool is required. part # 1951350 Learn More