TeraFlex

Front Axle Bracket Front Upper FlexArm Mount With Truss For 1997-06 Jeep Wrangler TJ & TJ Unlimited Models Fits Driver Side 3/16" steel Raw steel Includes truss Welding required The TeraFlex TJ front axle bracket driver upper FlexArm mount with truss is precision laser cut from 3/16” steel and accurately formed to ensure proper positioning for correct suspension geometry. Item is sold in raw steel and is ready for welding and paint or powder coating. This kit includes one upper driver... Read More Learn More

Front S/T Swaybar Link Hardware For 1997+ Jeep Wrangler TJ & TJ Unlimited Models & JK 2 Door & Unlimited 4 Door Models The TeraFlex S/T swaybar component hardware kit includes all of the items needed to install an S/T swaybar, including the swaybar link rod ends and jam nuts. Learn More

The brake light extension is designed to allow the use of a larger full size spare tire and retain the factory third brake light for safety. The extension is designed as a complete bolt-on accessory with no drilling required. It will accommodate tires up to 33". If the tire is mounted on a wider aftermarket wheel and tire combination with additional offset than factory, a tire extension must be used (Part # 1907200). Details: Black powder coat TeraFlex 3rd brake light extender bracket Learn More

These bumpstops extend your factory bump stop pad to control the front suspension compression so your large tires wont damage your fenders. Details: 2.25 in. tall 2 in. O.D. Learn More

A shift linkage kit may be necessary to properly locate your transfer case linkage when a body lift is used on TJ Wranglers. Details: NP231 transfer case For use with body lifts or transfer case drops Learn More

The TeraFlex FlexArm joint rebuild kit includes all required replacement components to rebuild a TeraFlex FlexArm joint. Depending on vehicle driving condtions, grit, grime, dust and fluids all take their toll on the tolerances of the bushings. To keep the joint functioning correctly it is necessary to rebuild the joint periodically and restore the joint to top working condition. This kit includes a chrome plated misalignment ball, two urethane bushings, large retainer washer, and snap... Read More Learn More

Replacement Lower QD Pin - 3/4" Replacement part. To be used with part numbers 1743092 and 1743090. Learn More

When mounting the TJ Wrangler HD Gas Tank Skid Plate (Part # 4940071), if no body lift is installed, this separate hardware mounting kit is required. Learn More

When running aftermarket wheels or larger tires it is necessary to extend the mounting point of the wheel from the vehicle. It also helps to raise the spare tire to allow for clearance between the bottom of the tire and the rear bumper. This simple bracket allows you to accomplish both tasks. Extension 2.75" Offset Up (Rise) 1.75" Note: Based on the offset of the wheel, and tire size used this bracket may allow you to mount a tire that is too large to be supported by the factory bracket. If too... Read More Learn More

This bracket kit is designed to work with our aluminum hex tie-rod & drag link tubing used in our High Steer Kit. Combine this kit with the steering stabilizer to complete your steering system. Details: Mounting Brackets Hardware Kit Fits: 1997-2006 Jeep Wrangler TJ and Unlimited 1987-1995 Jeep Wrangler YJ 1984-2001 Jeep Cherokee XJ 1993-1998 Jeep Grand Cherokee ZJ Learn More