Steering - Upgrades

Tera has developed heavy duty tie rod ends that utilize a one-ton joint end, and are available in either a stock Jeep taper or a large one-ton taper (standard Dana 60). The stock taper rod ends will fit Dana 30 knuckle holes. The large taper will fit the larger 60 type knuckles, as are used in Tera"™s HD axle line. Additionally the tie rod ends are available with an offset (for use with applications where differential interference may occur with the tie rod). Details: Left hand thread Small... Read More Learn More

The TeraFlex high steer system was originally designed to be used with our top of the line suspension system- the MAX-LCG, which utilizes a front 4-link triangulation (eliminating the trackbar). The High Steer Kit is essential in that application. We found that many Jeeps with more than 4" of lift while still utilizing a trackbar system would benefit from a high steer solution. This kit will beef up the essential steering components of your Dana 30 front axle. The system includes a HD tie rod... Read More Learn More

The TeraFlex TJ: Pro LCG Dana 30/44 High Steer System addresses many front-end steering issues associated with lifted TJ Wrangler/Unlimited models. Beefs up steering components, maximizes ground clearance, and corrects steering geometry. Learn More

Rough Country Heavy Duty Tie Rod Kit For 1984-06 Jeep Wrangler TJ & TJ Unlimited, Jeep Cherokee & Comanche Pick Up, Jeep Grand Cherokee ZJ Learn More

Rough Country Steering Box Brace For 1997-02 Jeep Wrangler TJ Learn More

The Synergy Steering Alignment Plates are essential to any DIYer's garage. No more lining up yard sticks and hoping they don't fall! Bolting directly to the wheel stud, these plates allow you to acquire the most accurate readings when setting your toe alignment on your vehicle. Learn More

Our Synergy Weld-In Forged Tube Adapters with Double Adjusters are the answer to your fabrication frustrations! Forget about spendy tap sets and annoying jam nuts. We use these exact ends on our highest quality steering components allowing us to use the heavy duty rod ends of our choice. Learn More

Our Synergy Weld-In Forged Tube Adapters with Double Adjusters are the answer to your fabrication frustrations! Forget about spendy tap sets and annoying jam nuts. We use these exact ends on our highest quality steering components allowing us to use the heavy duty rod ends of our choice. Learn More

The Synergy Drag Link and Tie Rod End Replacement Hardware Kit is a must-have service item to have on hand! Each kit is designed to replace the hardware on both your tie rod and drag link tie rod ends. Proper maintenance and services ensure the safety and reliability of your steering system, and replacing corroded hardware is essential during bolt checks and regular services. Learn More

These Synergy HD Replacement Tie Rod End Boots are made from tear and wear resistant black nitrile-butadiene rubber (NBR) for maximum durability. Ensuring a tight seal on the tie rod end prevents premature wear on the internals of the rod ends. Learn More